Select Or Cancel Upside-Down Print Mode - CognitiveTPG A799II Programming Manual

62 Chapter 4: Programming Commands
0E = Code Page 1255
0F = Code Page KZ_1048
10 = Code Page 1254
11 = Code Page 1250
12 = Code Page 28591
13 = Code Page 28592
14 = Code Page 28599
15 = Code Page 28605
16= Code Page 864
17 = Code Page 720
18 = Code Page 1256
19 = Code Page 28596
1A = KATAKANA
1B = Code Page 775
1C = Code Page 1257
1D = Code Page 28594
FD = UTF-8 with bidrectional support *takes longer to process, use as needed
FE = UTF-8 left-to-right only
Default:
0 (Code Page 437)
Selects the character set to be used until the printer is initialized, reset, or powered off. Look in "Appendix B: Resident
Character Sets" in this programming guide for the character sets. The alphanumeric characters (0x20-0x7F) are the same
for each set.
There are two codes for this command (See "Select international character code", 1B 52 n.) Both codes perform the same
function.
Related information
The LEGACY emulation selection applies only to the command "Select international character code" (1B 52 n).
The LEGACY emulation generates the same as Native mode for the command "Select international character set" (1B 74
n).

Select or cancel upside-down print mode

ASCII
ESC { n
Hexadecimal
1B 7B n
Decimal 27 123 n
Value of n:
0 = Cancel
1 = Set
Default: 0 (Cancel)
Prints upside-down characters until the printer is initialized, reset, or powered off. The command may be combined with
clockwise rotated print (1B 56) or counter-clockwise rotated print (1B 12). The character order is inverted in the buffer
so text is readable. Only bit 0 is used. Bits 1-7 are not used. See summary of rotated printing in this document for more
information.
Exceptions
The command is valid only at the beginning of a line. It cannot be used with right side up characters on the same line.
A799-2PG0001B 4/2016