Select Or Cancel 90 Degree Clockwise Rotated Print; Select International Character Set - CognitiveTPG A799II Programming Manual

Selects the character set to be used until the printer is initialized, reset, or powered off. Look in "Appendix B: Resident
Character Sets" in this programming guide for the character sets. The alphanumeric characters (0x20-0x7F) are the same
for each set.
There are two codes for this command (see select international character set, 1B 74 n). Both codes perform the same
function.
Related information
The LEGACY emulation selection applies only to the command "Select international character code" (1B 52 n). The
LEGACY emulation generates the same as Native mode for the command "Select international character set" (1B 74 n).

Select or cancel 90 degree clockwise rotated print

ASCII
ESC V n
Hexadecimal 1B 56 n
Decimal 27 86 n
Value of n:
0 = Cancel
1 = Set
Default:
0 (Cancel)
Rotates characters 90 degrees clockwise. The command remains in effect until the printer is initialized, reset, powered
off, or until a clear printer (0x10) or rotated print (1B 12) command is received. See summary of rotated printing in this
document.
This command does not affect HRI characters.

Select international character set

ASCII:
ESC t n
Hexadecimal: 1B 74 n
Decimal: 27 116 n
Value of n:
Native mode
0 = Code Page 437
1 = Code Page 850
2 = Code Page 852
3 = Code Page 860
4 = Code Page 863
5 = Code Page 865
6 = Code Page 858
7 = Code Page 866
8 = Code Page 1252
9 = Code Page 862
0A = Code Page 737
0B = Code Page 874
0C = Code Page 857
0D = Code Page 1251
A793 emulation
0 = Code Page 437
Not 0 = Code Page 850
A799-2PG0001B 4/2016
Chapter 4: Programming Commands 61