Transmit Paper Sensor Status; Transmit Printer Id - CognitiveTPG A799II Programming Manual

88 Chapter 4: Programming Commands

Transmit paper sensor status

ASCII ESC v
Hexadecimal
1B 76
Decimal
27 118
Values:
Status Byte (RS-232C)
Bit Function 0 Signifies
0 Paper low Not low
1 Receipt cover Closed
2 Receipt paper Present
3 Knife position Home position
4 Not used Fixed to zero
5 Temperature In valid range
6 Voltage In valid range
7 Not used Fixed to zero
Sends status data to the host computer. The printer sends one byte to the host computer when it is not busy or in a fault
condition. In DTS/DSR protocol, the printer waits for DSR = SPACE.
Related information
See busy line and fault conditions in the real time commands section of this document for details about fault condition
reporting.
In LEGACY emulation, this command is ignored.

Transmit printer ID

ASCII
GS I n
Hexadecimal 1D 49 n
Decimal 29 73 n
Value of n:
1, 49 = Printer model ID
2, 50 = Type ID
3, 51 = ROM version ID
4, 52 = Logo Definition
Transmits the printer ID specified by n as follows:
n Printer ID Specification
1, 49 Printer model ID A799II
2, 50 Type ID Installed options
3, 51 ROM version ID ROM version
4, 52 Logo definition Logo definition
n = 2 or 50: Type ID
Bit Off/On Hex Decimal
0 Off 00 0
On 01 1
1 Off 00 0
1 Signifies
Low (only if paper low sensor is enabled)
Open
Out
Not home position
Fixed to zero
Too hot or too cold
Too high or too low
Fixed to zero
ID (Hexadecimal)
0x25
Refer to below
0x00
Refer to next
page
Function
No two-byte character code installed.
Two-byte character code installed.
No knife installed.
A799-2PG0001B 4/2016