Download Application; Reset Firmware - CognitiveTPG A799II Programming Manual

Download application

ASCII
GS DC1 NUL NUL NUL NUL d1... dn
Hexadecimal 1D 11 00 00 00 00 d1... dn
Decimal 29 17 0 0 0 0 d1... dn
Value of d:
data bytes, 0–255
Sending this command followed by an application will download the application to the printer. This will reprogram the
flash.
Related information
Available only in download mode.
For more information, contact your service representative.

Reset firmware

ASCII
GS (SPACE)
Hexadecimal
1D FF
Decimal 29 255
Ends the load process and reboots the printer. Before executing this command, the printer should have firmware loaded
and external switches set to the runtime settings. Application software for downloading should prompt the user to set the
external switches and confirm before sending this command. If the downloading was started from a diagnostic, the reboot
will cause the printer to re-enter download state unless the external switches are changed.
A799-2PG0001B 4/2016
Chapter 4: Programming Commands 133