Select Or Cancel Double-Strike; Select Or Cancel Italic Print - CognitiveTPG A799II Programming Manual

Select or cancel double-strike

ASCII
ESC G n
Hexadecimal
1B 47 n
Decimal 27 71 n
Value of n:
0 = Off
1 = On
(When 0 and 1 are the least significant bit, LSB)
Default:
0 (Off )
Turns double-strike mode on or off until the printer is initialized, reset, or powered off. Identical to emphasized mode. The
printer is reset to the standard print mode after a clear printer (0x10) command is received.
Exceptions
Only the lowest bit of n is effective. The settings do not apply in page mode. However they can be set or cleared in page
mode.
Double-strike printing cannot be used with bit-images or downloaded bit-images.
This command does not affect HRI characters.
Related information
This command and the select print mode(s) command (1B 21) function identically. They should have the same setting
when used together.
In A793 emulation, this command is unrecognized and the parameter byte is put into the print buffer.

Select or cancel italic print

ASCII ESC I n
Hexadecimal 1B 49 n
Decimal
27 73 n
Value of n: 0 = Off
1 = On
(When 0 and 1 are the least significant bit, LSB)
Default: 0 (Off )
Turns italic print mode on or off. The printer is reset to the standard print mode after a clear printer (0x10) command is
received.
Exceptions
Only the lowest bit of n is valid.
Related information
This command is recognized in Native mode.
In A793 and LEGACY emulations, the parameter byte is put into the buffer.
A799-2PG0001B 4/2016
Chapter 4: Programming Commands 59