Bluetooth Forget All Devices; Bluetooth Diagnostic; Bluetooth Default - CognitiveTPG A799II Programming Manual

138 Chapter 4: Programming Commands

Bluetooth Forget All Devices

ASCII
US HT SOH BEL
Hexadecimal
1F 7F 01 07
Decimal 31 127 1 7
Instructs the Bluetooth module to forget all paired devices. This means that devices previously paired with the printer will
need to be paired again.

Bluetooth Diagnostic

ASCII US HT SOH ACK
Hexadecimal 1F 7F 01 06
Decimal 31 127 1 6
Prints a diagnostic summary of all configuration variable values in the Bluetooth module. This is the only command
that will work when the printer is not in configure mode. However, if a Bluetooth device is connected to the printer this
command will only work in configure mode.

Bluetooth Default

ASCII US HT SOH BS n
Hexadecimal 1F 7F 01 08 n
Decimal
31 127 1 8 n
Value of n: n specifies Force
n = 0 set variables to default values when the printer is in configure mode
n = 1 force the Bluetooth module to be configured to default settings regardless of which mode the printer is in
Sets all Bluetooth configuration variables to their default values. When force is set to 0, this command is used like all the
other Bluetooth configuration commands.
When force is set to 1, the command will be executed even if the printer is not in configuration mode. Additionally after
default values are set a Bluetooth reset will be automatically performed so the new values take effect immediately. This
takes the printer out of configuration mode.
A799-2PG0001B 4/2016