Configuring The Printer - CognitiveTPG A799II Programming Manual

16 Chapter 4: Programming Commands

Configuring the printer

The configuration menu allows you to select functions or change various settings for the printer. Instructions printed on the
receipt guide you through the processes.
Caution: Be extremely careful changing any of the printer settings to avoid changing other settings that might affect the
performance of the printer.
1 Turn power off to printer.
2 Make sure receipt paper is loaded in the printer before
proceeding. Make sure cover is closed.
3 Apply power to printer and immediately press and hold
the paper feed button until the configuration printout
begins.
• The printer beeps, then prints Diagnostics Form I.
• Press the paper feed button within two seconds to
enter the configuration main menu.
• The printer prints Diagnostics Form II, followed
by the Printer Configuration Menu, and waits for
a main menu selection to be made (see sample
printout on page 13; short clicks are used, except
when answering "yes" or validating selection).
Receipt
Cover
Receipt
Paper
Paper Feed
Button
A799-2PG0001B 4/2016
4 To communicate with the printer, you will press the
paper feed button using either short or long clicks. Use
a long click for "yes" (more than one second) and a
short click for "no." Follow the printed instructions to
make selections.
5 Continue through your menu selections until you are
asked, "Save New Parameters?" Select "Yes."
a Reset the Printer.
b Open the receipt cover.
Press and hold the paper feed button while closing
the receipt cover.
• The diagnostic printout verifies your new settings.