Jam Errors; Jam At Fuser: Jam F - Xerox phaser 6250 Service Manual

Jam Errors

Jam at Fuser: Jam F

■
Reseat the Fuser.
■
Remove the Fuser and check for any obstructions, media or debris.
■
Cycle printer power.
■
If the problem persists, follow the procedure below.
Troubleshooting Reference
Applicable Parts
Fuser, PL 8.1.1
Exit Sensor/Actuator, PL 8.1.7
Motor Driver Board, PL 12.1.12
Warning
To avoid the potential of electric shock, ensure the power to the printer is off
and the power cord is disconnected from the wall outlet prior to performing
Step 2 of the following troubleshooting procedure..
Troubleshooting Procedure
Steps Actions and Questions
1 Check the following for evidence of fault or
damage:
Exit Actuator & Sensor, PL 8.1.7
Fuser Assembly, PL 8.1.1
Front Cover, PL 1.1.2
Chute Assembly In, PL 5.1.1
Transfer Roller, PL 8.1.12
Imaging Unit, PL 9.1.3
2 Remove the Fuser and check for broken or
bent pins.
3 Reinstall the Fuser.
Does error recur after the Fuser Assembly
has been replaced?
4 Use service diagnostics to test the Exit
Sensor.
Does the sensor function correctly?
5 Does error recur after the Fuser is replaced Go to Step 6.
Error Messages and Codes
Wiring and Plug/Jack Map References
"Drive Section" on page 10-18
"Fuser Assembly" on page 10-21
"Map 1" on page 10-6
Yes
Replace the
part(s) concerned.
Replace the parts
concerned.
Go to Step 4.
Go to Step 9.
manuals4you.com manuals4you.com
No
Go to Step 2.
Go to Step 3.
Complete.
Replace the
Fuser Assembly.
Go to Step 5.
Complete.
3-19