Service Diagnostic Tests - Xerox phaser 6250 Service Manual

Service Diagnostic Tests

Test
Print Service Menu Map
diagnostics.
General Status - Provides the following print engine status:
Status
Engine Board
ROM Version
Printer
Configuration
Ambient
Temperature/
Humidity
Fuser
Temperature
Fault History
Test Prints - Prints test prints stored in the Engine Control Board. The prints are used by
service personnel to identify, repair and validate the operability of the printer.
Error Messages and Codes
Front Panel Display and Test Definition
- Prints the service diagnostics menu map and exits service
<No Status to Report>
NOTE This is current status since
entering diagnostics only. It is
not a Fault Log. If Ready is
reached, the register is
cleared.
Engine FW: #.#.#
Memory: ###MB
Hard Drive: Not Installed or
Installed
HCF: Installed
Not Installed
o
Temperature: XX C
Humidity: ## %
o
Temperature: XX C
Device Status
Jams
Hardware Errors
Firmware Errors
Fan Motors
CTD (ADC) Sensor Errors
Fuser Failure
Laser Failure
Life Over
Trays
Miscellaneous
CRUMS
No Status to Report = the printer
is online and ready to print.
Displays an engine status that will
prevent printing. Status is
displayed sequentially, one line at
a time.
Displays the engine firmware
version installed.
Displays current memory installed.
Detects presence of Hard Drive
option.
Detects presence of High-Capacity
Feeder option.
Displays the current Temperature
and Humidity for the printer.
Displays the printers current Fuser
temperature.
Displays Fault occurrence since
last power cycle.
manuals4you.com manuals4you.com
3-9