Panasonic KX-TDA100 Feature Manual page 37

• SLT Hold Mode
It is possible to choose how to hold and transfer a call with an SLT through system programming. The
following methods are available:
Hold
Flashing the
hookswitch
Mode 1
Going on-hook
Flashing the
hookswitch
Mode 2
Hold Feature No.
(Default)
Going on-hook
Flashing the
hookswitch
Hold Feature No.
Mode 3
Going on-hook
Flashing the
hookswitch
Hold Feature No.
Mode 4
Going on-hook
*: These operations must be performed when the held call is intended to be retrieved from another
extension using the holding extension number.
If one of the following occurs frequently with an SLT, choose "Mode 2", "Mode 3", or "Mode 4":
a)
When an SLT user answers a call, a reorder tone is heard or no one is heard on the other end.
b)
When an SLT user goes off-hook, a reorder tone is heard instead of a dial tone.
If a call is not terminated after going on-hook, the above cases occur. To avoid these problems, choose
"Mode 2", "Mode 3", or "Mode 4". Every call will be terminated unless the Hold feature number is
entered after flashing the hookswitch in Mode 2, Mode 3, and Mode 4.
• Hold Alarm tone pattern has a default. (→ 2.3 Tones/Ring Tones)
Hold
(to be Retrieved from
Another Extension)
Flashing the hookswitch
+
Hold Feature No.
Going on-hook
Flashing the hookswitch
+
Hold Feature No.
+
Going on-hook
Flashing the hookswitch
+
Hold Feature No.
+
Hold Feature No.
Going on-hook
Flashing the hookswitch
+
Hold Feature No.
+
Hold Feature No.
Going on-hook
Transfer to Trunk
*
Flashing the
hookswitch
+
Trunk Access No.
+
Flashing the
hookswitch
+
Trunk Access No.
+
Flashing the
hookswitch
+
Hold Feature No.
+
Trunk Access No.
+
Flashing the
hookswitch
+
Hold Feature No.
+
Trunk Access No.
+
Transfer to
Extension
Flashing the
hookswitch
+ +
Extension No.
Flashing the
hookswitch
+ +
Extension No.
Flashing the
hookswitch
+ +
Extension No.
+
Flashing the
hookswitch
+ +
Hold Feature No.
+ +
Extension No.
Feature Manual
1.3 C
37