Panasonic KX-TDA100 Feature Manual page 237

– Hardware Requirement
The KX-TDA6920, KX-TDA0920 or KX-TDA5920 SD Memory Card for Software Upgrade to
Enhanced Version
– This feature is not available when the PBXs are connected by a VoIP network.
– System programming is required to enable this feature.
• When a TIE line call arrives at a busy extension which has disabled Call Waiting, the caller will hear a
busy tone. If required, Intercept Routing can be activated.
• The Inter-digit time can be assigned for TIE line calls.
→ 2.8.4 [2-3] Timers & Counters—Miscellaneous—Receiving Dial Inter-digit Timer—TIE
Programming References
PC Programming Manual
2.7.14 [1-1] Slot—PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only)—Network Numbering Plan—Trunk
Property (for CO port)
2.7.17 [1-1] Slot—T1 Port (KX-TDA100/KX-TDA200/KX-TDA600 only)—Trunk Property (for TIE channel)
2.8.4 [2-3] Timers & Counters—Miscellaneous—Receiving Dial Inter-digit Timer—TIE
2.8.8 [2-6-1] Numbering Plan—Main—Features
→ Idle Line Access (Local Access)
→ Trunk Group Access
→ TIE Line Access
2.8.8 [2-6-1] Numbering Plan—Main—Other PBX Extension
2.8.11 [2-7-1] Class of Service—COS Settings—TRS—TRS Level—Day, Lunch, Break, Night
2.8.17 [2-9] System Options—Option 4—Private Network—Common Extension Numbering for 2 PBXs
(Optional SD Card Required)
2.9.1 [3-1-1] Trunk Group—TRG Settings—Main—COS
2.15.1 [9-1] TIE Table
2.16.2 [10-2] DIL Table & Port Settings
→ DIL—Trunk Property
→ DIL—DIL Destination—Day, Lunch, Break, Night
→ DID/TIE
2.16.3 [10-3] DID Table (KX-TDA100/KX-TDA200/KX-TDA600 only)—DID Destination—Day, Lunch,
Break, Night
PT Programming Manual
[453] DID Destination (KX-TDA100/KX-TDA200/KX-TDA600 only)
[500] Trunk Group Number
Feature Manual References
1.1.3 ARS (Automatic Route Selection)
1.3.8 Call Transfer
1.4.7 DISA (Direct Inward System Access)
1.6.4 Flexible Numbering/Fixed Numbering
1.6.6 FWD (Call Forwarding)
1.9.11 Intercept Routing
1.17.6 TRS (Toll Restriction)
2.1 Capacity of System Resources
1.13 P
Feature Manual 237