Panasonic KX-TDA100 Feature Manual page 242

1.13 P
2.
Network PBX ID Assignment
Assign a Network PBX ID to each PBX in the network.
→ 2.15.2 [9-2] Network Data Transmission—Network BLF Data Transmission for Centralized Operator
Feature—Network PBX ID
• IDs 1-8: Can monitor extensions at other PBXs, and transmit monitor data about local extensions.
Each ID number can be assigned to one PBX within the network.
• ID 0: Retransmits monitor data throughout the network. This ID number can be assigned to multiple
PBXs.
3.
QSIG Port Setting [Monitored PBX]
ISDN-QSIG (PBX Direct Connection)
Each QSIG port of a PRI card that will be used to transmit extension status information must be set to
do so through system programming. Even if a port is set to not transmit information, it will still receive
information from other PBXs.
→ 2.7.14 [1-1] Slot—PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only)—CO Setting—Networking
Data Transfer
Transmit
Enabled
Disabled
Set the transmission setting for each port according to the layout of your network, so that extension
status information can travel between NDSS monitor PBXs.
[Example ISDN Network Port Setting]
4001 NDSS
Idle
Busy
IP-GW-QSIG
IP data is routed through the network according to the routing tables of the IP-GW cards. When using
242 Feature Manual
Extension Status Information Functions
• Transmit information on own PBX extensions
• Receive information from other PBXs; forward it to other QSIG ports of the
PBX
• Re-transmit information received by other QSIG ports of the PBX
• Receive information from other PBXs; forward it to other QSIG ports of the
PBX
PBX-1
OFF
Network ID 1
ON
4001
Busy
ON
PBX-3
OFF
4001
Busy
ON
4001
Busy
PBX-5
PBX-2
OFF
Network ID 0
OFF
OFF
PBX-4
ON
Network ID 3
4001
Idle Busy