Panasonic KX-TDA100 Feature Manual page 231

4.
TIE Line Routing and Modification Table
3.1
To Make a TIE Line Call
The TIE Line Routing and Modification Table is referenced by the PBX to identify the CO line route
when an extension user makes a TIE line call.
It is necessary to make unified tables with all PBXs in the TIE line network.
The routing pattern appropriate for each call is decided by the dialed number.
There are two system programmes for the tables:
TIE Line Routing Table: used to assign the leading numbers (PBX code or extension number)
and trunk group hunt sequence.
→ 2.15.1 [9-1] TIE Table—Leading Number
TIE Modify Removed Number of Digits/Added Number: used to remove digits from and add a
number to the dialed number of the TIE line call. This modification may be needed depending on
the TIE line network configuration.
2.15.1 [9-1] TIE Table
→ Removed Number of Digits
→ Added Number
→ Trunk Group
[Programming Examples]
Your PBX is PBX-1 and there are four PBXs in your TIE line network. To identify the CO line route
as illustrated, you should make the following tables.
a)
Extension Number Method (Access without PBX Code)
2.8.8 [2-6-1] Numbering Plan—Main—Other PBX Extension—Dial
If you dial:
a) 2xxx
b) 3xxx
c) 4xxx
(2, 3, 4: Other PBX
Extension Number
[TIE] in the Flexible
Numbering Plan)
PBX-4
Extn. 4xxx
b-2nd) 3xxx
c) 4xxx
TRG 2
TRG 1
Extn. 1xxx
PBX-1
TIE Line Network
PBX-3
a) 2xxx
b-1st) 3xxx
PBX-2
1.13 P
Extn. 3xxx
Extn. 2xxx
Feature Manual 231