Panasonic KX-TDA100 Feature Manual page 164

1.9 I
• Idle Extension Hunting
If an extension is a member of an idle extension hunting group, calls to that extension will not be
redirected by Intercept Routing—Busy/DND. If the extension is busy or in DND mode, calls to that
extension will be redirected to the next extension in the idle extension hunting group.
• Intercept Routing for intercom calls can be enabled or disabled on a system basis.
→ 2.16.6 [10-4] Miscellaneous—Intercept—Intercept Routing for Extension Call (MPR Software File
Version 3.1000 or later)
• IRNA Timer
The IRNA timer can be set on a system basis and an extension basis for each time mode (day, lunch,
break, night).
→ 2.10.1 [4-1-1] Wired Extension—Extension Settings—Intercept Destination—Intercept No Answer
Time—Day, Lunch, Break, Night (MPR Software File Version 3.1000 or later)
• The Intercept Routing destination for each time mode will not apply for Intercept Routing—Busy. When
the original destination is busy, the call is redirected to the Intercept Routing—Busy destination
assigned through system programming. If no destination is assigned the caller will hear a busy tone.
• When a call arrives at an extension that is currently receiving a call, the call will be redirected to the
extension's Intercept Routing—No Answer destination for each time mode.
• The time modes that are selected for CO line calls arriving at extensions and VM groups are decided
on a tenant basis.
[MPR Software File Version 3.0000]
• This feature cannot be performed on incoming intercom calls.
• Calls redirected by intercept Routing—No Answer/Busy/DND are directed to the same destination.
• When the original destination for a call is a PS Ring Group, VM Group (DTMF/DPT) or External Pager
(TAFAS), the intercept destination is assigned to the trunk group carrying the call.
When the original destination is DISA, Intercept Routing will only redirect the call if the DISA line is
busy. Once the call reaches the destination extension using the DISA feature, the call can be redirected
to the Intercept Routing destination assigned to that extension.
→ 2.9.1 [3-1-1] Trunk Group—TRG Settings—Intercept (not available for MPR Software File Version
3.1000 or later)—Intercept Destination—Day, Lunch, Break, Night (not available for MPR Software File
Version 3.1000 or later)
→ [470] Trunk Group Intercept Destination (not applicable for MPR Software File Version 3.1000 or
later)
• Intercept Routing—Busy/DND on/off
Intercept Routing—Busy and Intercept Routing—DND can each be enabled or disabled for the entire
system, through system programming. If enabled, calls will be routed to the appropriate destination.
If disabled, a call to an extension which is busy or in DND mode will be handled as described below,
depending on the type of CO line carrying the call.
→ 2.16.6 [10-4] Miscellaneous
→ Intercept—Intercept Routing - Busy (Destination is busy) (not available for MPR Software File
Version 3.1000 or later)
→ Intercept—Intercept Routing - DND (Destination sets DND)
a)
ELCOT/LCOT or T1 (LCOT/GCOT) Card: The caller will hear a ringback tone. If busy, the
extension will not ring. If in DND mode, the extension will ring.
b)
All other CO lines: The caller will hear a busy tone.
• IRNA Timer
The IRNA Timer cannot be set on an extension basis.
164 Feature Manual