AJA Ki Pro Ultra Installation & Operation Manual page 61

Ki Pro Ultra v1.2r1
NOTE: Other web browsers may work, but AJA cannot guarantee consistent operation for all web
browsers or web browser versions. If you do experience an unexpected behavior when using a
particular web browser or web browser version to interact with Ki Pro Ultra, consider using an
alternate web browser and report any issues experienced to AJA Technical Support.
To control Ki Pro Ultra remotely, connect a computer to the Ki Pro Ultra's LAN connector,
an RJ45 socket, via a CAT5 Ethernet cable.
To access Ki Pro Ultra, enter its URL in the web browser. The URL will be the IP address
defined in Ki Pro Ultra's Network parameter menus (Note that CONFIG menu parameters
50.1 through 50.4 must all be configured correctly to access Ki Pro Ultra on your
network). If Ki Pro Ultra is using DHCP (the default), the IP address can be found by going
to parameter 50.2 and reading it there. When Ki Pro Ultra is shipped from the AJA factory,
it defaults to DHCP operation. The DHCP selection is most useful in studio settings where
the camera or cameras may be connected to an existing IT infrastructure.
If 50.1 is set to DHCP, and the DHCP server on the network fails to grant an IP address,
then Ki Pro Ultra's 50.2 DHCP Address menu parameter will display 0.0.0.0. No connection
to the device can be made with this address. Check with your network administrator if
you experience issues connecting to the device over a DHCP network.
If 50.1 is set to Default Addr, the factory default static IP address 10.65.74.65 is used. So, if
50.1 is set to Default Addr, to see Ki Pro Ultra's web interface, you would type the
following in the web browser:
http://10.65.74.65
NOTE: Your computer or network must be configured to access this IP address. You may need to
make changes to your network settings on your host computer to access this IP address.
Figure 18. Default IP Address Configuration
61
www.aja.com