Rollover; Record Minutes (Max) - AJA Ki Pro Ultra Installation & Operation Manual

IMPORTANT:

12.2 ROLLOVER

IMPORTANT:
12.3 Record Minutes
(max)
Ki Pro Ultra v1.2r1
cannot use the transport functions. Additionally, the front panel UI states that the unit is
in a "DATA MEDIA STATE" in an obvious way as opposed to presenting the typical clip,
reel, timecode, etc. usually seen on the front panel.
After you select the Data state, you can connect the Ki Pro Ultra to a host computer via
the Ethernet connection. The Ki Pro Ultra will allow access to the selected media
designated by the highlighted LED. In other words, if the #2 media module is selected on
the Ki Pro Ultra, that would be the volume mounted by the host computer operating
system.
The DATA MEDIA STATE does not survive reboots or power cycles of the device. After such
an event, it returns to the default Record-Play mode.
When the Ki Pro Ultra is in the Media State and the Data - LAN selection is used, only the web
UI for control and configuration of the Ki Pro Ultra may be used for data transfer. The web UI
will present "Upload+" and "Download+" buttons in the All Clips portion of the UI. If the Data-
LAN state is not active, these buttons do not appear in the web UI.
This parameter determines whether the Ki Pro Ultra is configured to support recordings
that continue when the selected Pak media becomes full.
OFF: When the Rollover parameter is set to OFF, the Ki Pro Ultra performs recordings normally
and when the Pak media reaches the 10% of capacity "Media Full" point, recordings do
not continue onto additional media.
ON: When the Rollover parameter is set to ON recordings create "appended" files on
additional Pak media.
Example: a recording is begun on the first piece of Pak media, S1, and is called "SC1ATK1".
When this piece of Pak media reaches capacity, the second piece of Pak media (S2) is
seamlessly engaged and begins an appended recording, "SC1ATK1+1". This can continue
until this piece of media reaches capacity.
If a piece of media is inserted for a rollover and it does not meet the following criteria, rollover
recordings will not be possible:
• The rollover media needs to have already been formatted in the Ki Pro Ultra
• The rollover media needs to be completely empty; no clips can already be on the media
If the Rollover parameter is set to ON and rollover media does not meet the criteria
noted, warning alarms may appear such as:
• WARNING Media Unformatted
• WARNING Rollover Media Not Empty
This parameter specifies the maximum record length of clips. The range is 5 minutes to
240 minutes (4 hrs).
When the max clip time is reached Ki Pro Ultra automatically continues to record and
creates a new clip. The clip naming convention is the same as Rollover record (appending
+n to the file name). During playback, Ki Pro Ultra will play the clips as if they are one
continuous recording. When these clips are imported into a NLE, they can be seamlessly
combined into a single clip without audio or video drop out. These are the options:
5 to 240
(default = 240)
Press Control Knob and scroll up or down to change the Record
Minutes (max) value.
39
www.aja.com