AJA Ki Pro Ultra Installation & Operation Manual page 15

DISP Button: Use the display button to toggle video overlay display modes. Sequential presses of the
button step through these display modes:
1. No overlay – display is video monitor only
2. Top and bottom status overlay
3. Top and bottom status overlay plus VU meters
The display button can be used to hide the CONFIG or STATUS overlay if it is active.
User Control Knob: The User Control Knob on the right hand side of the Ki Pro Ultra front panel is used to
scroll through and select menu items. After scrolling to, and high-lighting a menu item of
interest, push the knob to select. To pop out of a selected menu item, use the rotator
knob to highlight EXIT and push the knob to return to the top level.
When not in a configuration mode and media is mounted with clips available, you can
use the selection knob to scroll through the clips. Press the knob once to enable JOG
mode to step through the clip a frame at a time.
STATUS Button: When it is not highlighted, you can press the STATUS button to display the status overlay.
Status includes video input, format, record format, and audio setup information. Once
selected, the selector knob can be rotated to display either the STATUS or ALARM tab. If
any ALARMS or WARNINGS are active, they will be displayed under the ALARMS tab.
When it is highlighted, pressing the STATUS button hides the STATUS overlay.
A blinking Status button indicates Alarms are present. Press the STATUS button to
immediately display the ALARM tab.
NOTE: When necessary, you can initiate a "safeboot" of the Ki Pro Ultra to factory presets by holding
in the Status button while powering up.
CONFIG Button: When it is not highlighted, you can press CONFIG to access the Ki Pro Ultra configuration
menu overlay. If the transport is active—video is playing or being recorded—you will be
prompted to stop the transport before entering configuration mode. Use the User
Control Knob to respond to system prompts by rotating and pushing to select. Once in
configuration mode the User Control Knob can be rotated to scroll the menu system.
Push the User Control Knob to enter a selected menu, scroll through the selections, push
to select a setting. To leave a menu, scroll to Exit and press the knob.
MEDIA Button: When it is not highlighted, you can press the MEDIA to enter the Media menu. Pressing
MEDIA when it is highlighted will turn Off the MEDIA menu (returning to the default
TRANSPORT menu). The MEDIA menu can only be entered from the transport STOP
mode. The MEDIA menu remembers which parameter it is set to when exited and will
return to that same parameter when the menu is re-entered.
Transport Control Buttons: The transport buttons are always active.
STOP : The STOP button has a dual function. When playing back a clip (PLAY, FFWD, or
REV) the first push of STOP acts as a "pause" mode: the playback is paused, the current
point of the clip is displayed, and the STOP button flashes. A second push of STOP
completely stops the playback and directs Ki Pro Ultra's outputs into an "E to E" mode
(the currently selected inputs bypass to the outputs). To determine at a glance if the
STOP button is in a "pause" mode, note that the stop button will flash if media playback is
paused. The STOP button is fully illuminated in "stop" mode.
PLAY >: Press PLAY to begin forward playback of the current clip at normal speed.
RECORD : Press the red RECORD button to begin recording. Once in RECORD mode, all
other transport buttons are locked-out except the STOP button.
Ki Pro Ultra v1.2r1 15 www.aja.com