AJA Ki Pro Ultra Installation & Operation Manual page 37

Ki Pro Ultra features a variety of alarms to help you diagnose the condition of the unit,
possible configuration issues, or possible signal issues. Here is a list of warning messages
and their meaning:
"WARNING Input Format Changed" prompt appears if a recording is started and the
signal is lost or changed. If this occurs, Ki Pro Ultra stops the recording that is in progress
(unless the Loss of Video CONFIG menu parameter is set to continue recording.)
"WARNING No Video Input" may appear if there is no video input to Ki Pro Ultra. No
recording will be performed in this state.
"WARNING Input Error" may appear if a format or frame rate that is not supported is
supplied to the Ki Pro Ultra or a link of a multi-link signal (dual link or quad link) is
missing; no recordings will be produced if this alarm appears.
"WARNING Dropped Frames" may appear if media is under-performing and cannot keep
up with the data rate required to make a recording or perform a playback. If you see this
prompt during recording, recordings will stop. If this prompt appears, you might
consider backing up your current recordings and formatting the media. For playback,
you might simply re-attempt playback.
"WARNING Media Low" will appear when the media only has 15% of capacity remaining.
Media must be switched out when it reaches 10% of capacity. With 10% of media
remaining, the "WARNING Media Full" prompt will appear.
"WARNING Media in Use" may appear if you try to use media while another operation is
still taking place. Wait for the operation to finish and then try again or press STOP.
"WARNING Media Not Present" may appear if media has been physically removed and
the user hits the slot button.
"WARNING Media Unformatted" may appear if Ki Pro Ultra does not recognize the file
system on the SSD media or the media has never been formatted.
"WARNING Storage Removed" will appear if the media is removed without first hitting
the SLOT button to properly unmount it. In the event this happens, media immediately
re-inserted into the Ki Pro Ultra may show clips as "N/A" and subsequent recordings may
not be possible. To resolve this issue, mount the media on an Apple computer under Mac
OSX, then remove and re-insert the media into your Ki Pro Ultra. If the media does not
read properly, you will need to format it. Additionally, this alarm will lead to the "Please
Reboot" prompt.
"WARNING Please Reboot" appears if media was removed without the use of the slot
button and the Ki Pro cannot continue operating and must be rebooted.
"WARNING Backup and Reformat" may appear if the media has issues being mounted by
the Ki Pro Ultra. As the prompt indicates, it is best to back up the media by copying it to
another hard drive or disk array and then reformat the media. Some signs that the media
is in a read-only state: even though clips have been recorded to the media, "N/A" appears
in the clip area of the UI, "Loading" appears in the clip area of the UI but does not
eventually load a clip, or hitting the record button with all settings correctly configured
for the Ki Pro Ultra does not result in a recording.
"WARNING Rollover Media Full" appears if media for a rollover is not empty and contains
existing recordings; the rollover feature requires empty media to operate.
"WARNING Rollover Media Unformatted" appears if media for a rollover is not formatted
or recognized.
"WARNING No Rollover" may appear if rollover is enabled, but no rollover media is
inserted or media that is not empty is present.
37
Ki Pro Ultra v1.2r1 www.aja.com