Operations Unique To The Web Ui; Updating Firmware - AJA Ki Pro Ultra Installation & Operation Manual

Operations Unique to the Web UI

Updating Firmware

Ki Pro Ultra v1.2r1
The buttons in this area can also be used to access the menu parameters in the same way
that the menu bar on the left hand side of the UI may be used. The transport buttons in
this area may be used for clip playback operation. The UI Control Knob emulation in this
area may be clicked to toggle from navigating clips to a jog playback mode. To navigate
or jog, use a scroll wheel-based mouse or swipe up or down on a trackpad.
The Update Firmware screen allows you to update your Ki Pro Ultra to later versions of
software as they are issued by AJA and posted on the website. When software updates
are released, they often contain new features, improvements, and bulletins that may be
very useful. We suggest checking the website when you have time.
Figure 21. Update Firmware Screen
Although Ki Pro Ultra comes from the factory pre-installed with software, it may not be as
up-to-date as the software currently posted on the AJA website. This topic describes the
steps required to upgrade the software in your Ki Pro Ultra.
NOTE: AJA recommends a Factory Reset under the CONFIG menu prior to updating firmware.
1. Download the Latest Ki Pro Ultra firmware.
Current and past releases of Ki Pro Ultra firmware are available from AJA's website. To get
the firmware, point your browser to:
www.aja.com
Access the support page and once you're at the update page, select the Ki Pro Ultra
firmware files for Mac or PC for download.
2. Unpack the Software
64
www.aja.com