Audio Sg; Ip Config; Ip Address; Subnet Mask - AJA Ki Pro Ultra Installation & Operation Manual

41.3 AUDIO SG

50.1 IP CONFIG

50.2 IP ADDRESS

50.3 SUBNET MASK

Ki Pro Ultra v1.2r1
This parameter determines the audio signal output from Ki Pro Ultra's internal test signal
generator. These are the options:
OFF (default)
Silence
1 kHz
This parameter determines the type of TCP/IP network configuration used by Ki Pro Ultra.
These are the options:
STATIC ADDR
DEFAULT ADDR
DHCP (default)
NOTE: With parameters 50.1, 50.2 and 50.3, there is no timeout when editing—changes made while
in these menus will be saved and activated when the menu is exited.
This parameter determines the static IP address used by Ki Pro Ultra for TCP/IP
networking.
variable
NOTE: For parameters 50.2, 50.3, and 50.4, you will be setting IP addresses that consist of "octets"
separated by a period (i.e., 10.0.181.0). To edit these, press the User Control Knob to access the
alpha-numeric keyboard to enter the desired IP Address. When complete click the SAVE
function.
This parameter determines the subnet mask used by Ki Pro Ultra for TCP/IP networking.
variable
Please read the "Note" about editing IP addresses in parameter 50.2 as it also applies to
parameters 50.3 and 50.4.
Turn audio test signal output OFF.
Output an audio test signal containing silence only.
Output a standard 1 kHz test signal tone.
Assign a static IP address manually (parameters 50.2,
50.3, and 50.4 will have to be entered to accomplish
this).
Use the factory default static IP address: 10.65.74.65
Select automatic IP address assignment from DHCP
server on LAN.
NOTE: if Ki Pro Ultra cannot find a DHCP server to
communicate with, it will select the default factory IP
address of 192.168.0.2.
Using the User Control Knob, enter an IP address compatible
with your LAN (if you have one). If direct connecting to a
computer, enter a legal IP address that you'll also enter in
the computer's web browser. This is only needed for Static
IP configurations.
NOTE: If 50.1 is set to DHCP and there is a DHCP failure, then
the default IP address is: 192.168.0.2
NOTE: If 50.1 is set to Default Addr, the default static IP address
is: 10.65.74.65
Using the User Control Knob, enter a subnet mask compatible
with your LAN (if you have one). This is only needed for
Static IP configurations.
NOTE: If 50.1 is set to DHCP, the default Subnet Mask will be
assigned by the DHCP server
NOTE: If 50.1 is set to Default Addr, the default Subnet Mask is:
255.0.0.0
55
www.aja.com