Throttle Position Sensor (Tps) (550/700/1000); Gear Position Switch - Arctic Cat 500 Service Manual

3. Using a multimeter, connect the black tester lead to
the black socket (GND) on the analyzer and the red
tester lead to the white socket (VAR); then select the
DC Voltage position.
should read 0.66-0.70 and at Wide-Open Throttle it
should read up to approximately 3.88.
Throttle Position Sensor
(TPS) (550/700/1000)
TESTING
1. Remove the seat, side covers, front rack, and front
body panel (see Steering/Frame/Controls); then
remove the air filter assembly. Remove the TPS con-
nector plug from the TPS.
FI672
With the vehicle off, the gauge
FI673A
PR544
 NOTE: Prior to testing the TPS, inspect the
three-wire plug connector on the main harness and
the three-pin plug on the TPS for contamination, bro-
ken pins, and/or corrosion.
 NOTE: If the vehicle is in warranty, removing or
adjusting the TPS will void warranty. If the TPS is
tested out of specification, the throttle body must be
replaced. If the vehicle is out of warranty, the TPS can
be adjusted.
2. Connect the TPS Multi-Analyzer Harness connector
#8 to the TPS; then connect the harness to the TPS
Analyzer Tool.
3. Using a multimeter, connect the black tester lead to
the black socket (GND) on the analyzer and the red
tester lead to the white socket (VAR); then select the
DC Voltage position.
should read 0.58-0.62 and at Wide-Open Throttle it
should read up to approximately 3.7.

Gear Position Switch

The gear position switch is located on the engine/trans-
mission next to the shift arm.
FI672
With the vehicle off, the gauge
CF329
209