Servicing Right-Side Components - Arctic Cat 500 Service Manual

13. Remove the snap ring securing the oil pump driven
gear (A); then remove the gear noting the direction
of the sides of the gear for installing purposes.
Account for a pin and a washer.
14. Using an impact driver, remove the three torx-head
screws securing the oil pump; then remove the pump.
114
Servicing Right-Side
INSPECTING CENTRIFUGAL CLUTCH
SHOE
1. Inspect the clutch shoes for uneven wear, chips,
cracks, or discoloration. If any shoe is damaged,
replace the complete set.
2. Inspect the clutch shoes for wear or damage. If any
CD999
shoe is worn to the bottom of the groove, replace the
clutch assembly.
INSPECTING CLUTCH HOUSING
CD984
1. Inspect the clutch housing for burns, grooving,
cracks, or uneven wear.
2. If the housing is damaged in any way, the housing
must be replaced.
INSPECTING PRIMARY
ONE-WAY DRIVE
1. Insert the drive into the clutch housing.
2. Rotate the inner race by hand and verify the inner
race rotates only one direction.
3. If the inner race is locked in place or rotates both
CD895A
directions, the drive assembly must be replaced.
INSPECTING OIL PUMP
1. Inspect the pump for damage.
2. It is inadvisable to remove the screw securing the
pump halves. If the oil pump is damaged, it must be
replaced.
CD988
Components
ATV1014