Arctic Cat 500 Service Manual page 166

CAUTION
Make sure the green dot (or the word OUTSIDE) is visi-
ble on the one-way clutch. Incorrect installation can
result in damage to the engine.
4. Place a new clutch housing seal (with the spring side
facing the clutch housing seal tool) into the clutch
cover and secure with a rubber mallet or press.
5. Using a suitable press, install the bearing into the
clutch cover against the outer bearing face.
 NOTE: It is critical to verify the seal on the bearing
faces the clutch cover seal before pressing in the new
bearing.
6. Secure the bearing in the clutch cover using existing
bearing retainers and machine screws (threads coated
with blue Loctite #242). Tighten to 8 ft-lb.
164
GZ247B
7. Press the clutch housing assembly into the clutch
cover until it is seated against the bearing.
8. Install a new O-ring into a new fixed drive spacer,
then apply a thin coat of grease to the inner O-ring
and outside sealing surface of the drive spacer. Place
it over the clutch housing assembly.
GZ503
9. Place the clutch cover/clutch housing assembly into
position on the crankcase; then secure with the cap
screws. Tighten in a crisscross pattern to 8 ft-lb.
GZ501
GZ508
GZ512
ATV2109