Arctic Cat 500 Service Manual page 114

3. Remove the V-belt.
4. Remove the bolt (550) or nut (700) securing the
fixed driven assembly; then remove the assembly.
550
700
5. Remove the fixed drive face.
6. Remove the cap screws securing the clutch cover.
Note the location of the different-lengthed cap
screws for installing purposes. Using a rubber mallet,
carefully remove the cover. Account for two align-
ment pins.
112
CD966A
Care must be taken when removing the cover so the
cover gasket is not damaged.
H1-019
 NOTE: For steps 7-13, refer to illustration CC829B.
 NOTE: To aid in installing, it is recommended that
the assemblies are kept together and IN ORDER.
PR388
KEY
A. Oil Pump Driven Gear
B. Oil Pump Drive Gear
C. Clutch Shoe Assembly
7. Remove the one-way clutch (D) from the clutch
housing. Note the location of the green alignment dot
(or the word OUTSIDE) for installing purposes.
8. Using a hydraulic press, remove the clutch housing
assembly from the clutch cover. Account for the left
fixed drive spacer and an O-ring inside the fixed
drive spacer.
CAUTION
D. One-Way Clutch
E. Final Drive Carrier Bearing
Housing
CD973A
CD974A
CC829B