Arctic Cat 500 Service Manual page 29

3. Install the tie rods and secure with the slotted nuts.
Tighten to 30 ft-lb; then install new cotter pins.
 NOTE: If the slots do not align with the holes in the
tie rod ends, tighten the nuts just enough to allow
installation of the cotter pins.
4. Install the front wheels and tighten to 40 ft-lb (steel
wheels) or 80 ft-lb (aluminum wheels) using a criss-
cross pattern.
5. Lower the ATV and place the handlebar and caps
into position on the steering post; then position the
LCD gauge on top of the caps and secure with the
four cap screws. Tighten securely.
6. Install the storage compartment box; then attach the
storage compartment cover assembly by engaging
the tabs into the slots and sliding rearward. Lock the
storage compartment lid to hold the assembly in
place.
7. Place the instrument pod into position; then secure
with two reinstallable rivets and the ignition switch
retaining ring.
CD760
8. Install the steering post access cover and secure with
four reinstallable rivets; then install and secure the
radiator access cover.
AF778D
FI464A
FI463A
FI466A
FI465A
27