Arctic Cat 500 Service Manual page 186

11. Use tape to cover and seal the intake opening.
CAUTION
Any objects or liquid entering the intake opening will
fall into the engine causing severe damage if the engine
is turned over or started.
REMOVING (1000)
! WARNING
Whenever the gasline hoses are removed (other than for
pressure testing), the battery must be disconnected to
prevent inadvertent activation of the electronic fuel
pump.
1. Remove the front rack and body panel.
2. Disconnect the wires from the IAT sensor; then
loosen the clamp and remove the inlet air boot from
the air filter housing.
184
3. Loosen the clamp on the throttle body intake boot;
then remove the air filter housing from the ATV.
4. Disconnect the three wiring connectors from the sen-
sors on the throttle body; then remove the cap screws
securing the throttle body to the intake manifold.
FI104A
5. Remove the throttle arm cover and disconnect the
throttle cable; then remove the throttle body from the
ATV.
GZ379
6. Use tape to cover and seal the intake opening.
Any objects or liquid entering the intake opening will
fall into the engine causing severe damage if the engine
is turned over or started.
INSTALLING (500/550/700)
1. Install the throttle body into the intake pipe and
secure with the clamp. Tighten securely.
GZ091A
CAUTION
GZ094B
GZ381A
GZ383A