Servicing Engine (550/700); Top-Side Components - Arctic Cat 500 Service Manual

26. Raise the rear of the engine enough to allow the rear
output flange to clear the output flange joint. Block
the engine up in this position.
27. Remove the first small boot clamp; then remove the
output flange and driveshaft from the rear drive cou-
pler.
28. Remove the block from under the engine and lower
the engine; then remove the boot clamp from the
front output drive yoke.
29. Move the engine to the rear enough to allow the front
driveshaft to clear the front output yoke; then move
the engine forward and to the left. The engine will
come out the left side of the frame.
88
CD811
Servicing Engine
CD812A
Top-Side Components.................................................88
Removing Top-Side Components................................89
Servicing Top-Side Components.................................92
Installing Top-Side Components .................................99
Left-Side Components ..............................................104
Removing Left-Side Components .............................104
Servicing Left-Side Components...............................106
Installing Left-Side Components ...............................108
Right-Side Components ............................................111
Removing Right-Side Components ...........................111
Servicing Right-Side Components ............................114
Installing Right-Side Components .............................115
Center Crankcase Components ................................118
Separating Crankcase Halves...................................118
CD813
Disassembling Crankcase Half .................................118
Servicing Center Crankcase Components ................120
Assembling Crankcase Half ......................................126
Joining Crankcase Halves.........................................127

Top-Side Components

 NOTE: For efficiency, it is preferable to remove and
disassemble only those components which need to be
addressed and to service only those components. The
technician should use discretion and sound judgment.
(550/700)
CD818
CD773