Cruise Speed (Cruise Control) - Seat TOLEDO Owner's Manual

Side lines: extension of the vehicle (the
1
approximate width of the vehicle plus the
rear view mirrors) on the road surface.
End of the side lines: the area marked in
2
green ends approximately 2 m behind
the vehicle on the road surface.
Intermediate line: indicates a distance of
3
approximately 1 m behind the vehicle on
the road surface.
Red horizontal line: indicates a safe dis-
4
tance of approximately 40 cm at the rear
of the vehicle on the road surface.
Parking manoeuvre
● Place the vehicle in front of the parking
space and engage reverse gear (manual
gearbox) or move the selector to the R posi-
tion (automatic gearbox).
● Reverse slowly, and turn the steering wheel
so that the side orientation lines lead to-
wards the parking space.
Guide the vehicle into the parking space so
●
that the side orientation lines run parallel to
it.

cruise speed (Cruise control)*

Introduction
Read the additional information carefully
›››

page 36
176
Operation
The cruise control system allows you to drive
at a constant speed of 30 km/h (19 mph) or
higher without having to press the accelera-
tor. However, the speed is only maintained
within the margin permitted by the engine
power and the braking effect of the engine.
The  warning lamp lights up on the general
instrument panel if cruise control is switched
on.
CAUTION
The cruise control cannot maintain a con-
●
stant speed when the vehicle is moving
downhill. The vehicle tends to accelerate un-
der its own weight. Therefore, shift down or
use the brake pedal in good time to slow the
vehicle.
Note
In vehicles with an automatic gearbox, the
●
cruise control system cannot be switched on
if the selector lever is in position P, N or R.
In vehicles with a manual gearbox, the
●
cruise control cannot be switched on if first
gear or reverse gear is engaged.
Setting the speed
Fig. 185 Turn signal and main beam head-
light lever: cruise control buttons.
Setting speed
›››
Fig. 185 to the ON posi-
Move knob
– 1
tion.
Briefly press rocker switch
– 2
tion when you have reached the speed you
wish to set.
On releasing rocker switch from SET, the
2
current speed is stored and will remain con-
stant without having to press the accelerator
pedal.
in SET posi-