Seat TOLEDO Owner's Manual page 173

Manual disconnection of Parking Aid
Press the  button again.
●
Manual disconnection of Parking Aid display
(the audible sounds remain active)
● Press a button on the main menu of the fac-
tory-assembled infotainment system.
● OR: press the BACK function button.
Automatic connection of Parking Aid
● Engage reverse gear or turn the selector
lever to position R.
OR: If the vehicle approaches an obstacle
●
that is in its forwards path at a speed below
›››
page 171, Automatic ac-
10 km/h (6 mph)
tivation. The obstacle is detected as of a dis-
tance of approx. 95 cm if the automatic con-
nection is activated in the infotainment sys-
tem. A reduced display is shown.
Automatic disconnection of Parking Aid
● Move the selector lever to position P.
OR: accelerate to more than approx.
●
10 km/h (6 mph) forward.
Temporary suppression of sound in Parking
Aid
● Press the  function button.
Driver assistance systems
Change from reduced view to full view
Engage reverse gear or turn the selector
●
lever to position R.
OR: press the car icon in reduced view.
●
If necessary, switch to the rear-assist image
(Rear View Camera "RVC")
● Engage reverse gear or turn the selector
lever to position R.
● OR: Press the RVC function button.
A short confirmation signal will be heard and
the button symbol will light up yellow when
the system is switched on.
Automatic activation
Miniature indication of automatic ac-
Fig. 181
tivation
When the Parking System Plus is switched on
automatically, a miniature of the vehicle will
be displayed and the segments will be
shown on the left side of the screen
›››
Fig. 181.
Automatic activation occurs when slowly ap-
proaching an obstacle located in front of the
vehicle. It only operates every time the speed
is reduced below approximately 10 km/h (6
mph) for the first time.
If the parking aid is switched off using the 
button, the following actions must be carried
out in order for it to automatically switch on:
● Switch off the ignition and switch it on
again.
OR: accelerate above 10 km/h (6 mph) be-
●
fore reducing speed below this number
again.
OR: place the selector lever in position P
●
and then move it from this position.
OR: switch on and off the automatic activa-
●
tion in the Easy Connect system menu.
The automatic activation with parking aid
miniature indication can be switched on and
off from the Easy Connect system menu
›››

page 25:
Switch the ignition on.
●
● Select: button > Settings > Parking
CAR
.
and manoeuvring
● Select the Automatic activation op-
tion. When the function button check box is
activated , the function is on.
»
171