Seat TOLEDO Owner's Manual page 191

Placing in service position
Fig. 194 Placing in service position.
Towing bracket device
Service position.
Fig. 195
Before assembling, place the ball-headed bar
in service position.
Turn key fully in the direction of arrow
–
A
›››
Fig. 194.
1
Hold the ball-headed bar with your left
–
hand.
Pull manual regulator outward in the di-
–
B
rection of arrow and turn it fully in the
2
direction of arrow .
3
The manual regulator will remain in this posi-
tion.
›››
Service position Fig. 195
Key is in an open position – the key ar-
●
C
row points to the "unlocked" symbol. The key
cannot be removed from the key slot.
● The locking balls may be fully inserted
D
into the body of the ball-headed bar by ap-
plying some pressure.
The red marking on the manual regula-
●
E
tor points towards the white marking on the
ball-headed bar.
● Between the manual regulator and the
body of the ball-headed bar there is a clearly
visible space of approximately 4 mm
Once the ball-headed bar has been posi-
tioned like this, it will be ready to be placed
in the clamping bush.
WARNING
Do not use the ball-headed bar if it cannot be
correctly placed in the service position.
CAUTION
The key cannot be removed from the manual
regulator key slot when it is in the service po-
sition.
.
F
189