Seat TOLEDO Owner's Manual page 56

Wheel bolt caps
Pull off the wheel bolt cap.
Fig. 61
Removing
Fit the plastic clip (vehicle tools) over the
●
cap until it clicks into place
● Remove the cap with the plastic clip.
Fitting
Insert the caps as far as they will go over
●
the wheel bolts.
The wheel bolt caps are stored in a box on
the spare wheel or in the spare wheel well.
1) The corresponding adapter is required to unscrew
or tighten the anti-theft wheel bolts
54
Anti-theft wheel bolts*
Anti-theft wheel bolt with adapter.
Fig. 62
Anti-theft wheel bolts (one bolt per wheel)
can only be loosened or tightened using a
factory-supplied adapter.
›››
Fig. 61.
● Pull off the hub cap or bolt cover.
● Insert the adapter
toothed side as far as it will go on the interior
toothing of the anti-theft wheel bolt
that only the outer hexagonal is protruding.
● Fit the box spanner as far as it will go over
adapter
Loosen or firmly tighten the wheel bolt
●
›››
page 54.
After removing the adapter, replace the hub
●
cap or the anti-theft wheel bolt cover.
›››
page 54.
The essentials
›››
Fig. 62 with its
B
so
A
.
B
● Check the tightening torque as soon as
possible with a torque wrench.
Note down the code number stamped on the
front of the adapter or of the anti-theft wheel
bolt. You will need this number to obtain a
spare adapter from the SEAT original acces-
sories programme.
You should always have a wheel bolt adapter
as part of your vehicle tools.
Loosening and tightening wheel bolts
Changing a wheel: loosen the wheel
Fig. 63
bolts.
Loosening wheel bolts
● Insert the box spanner onto the wheel bolt
1)
as far as it will go .