Seat TOLEDO Owner's Manual page 101

Hide thumbs Also See for TOLEDO:
Table of Contents

Advertisement

Depending on the equipment, some set-
tings and instructions can also be carried out
in the Easy Connect system.
When several warnings are active at the
same time, the symbols are shown succes-
sively for a few seconds and will stay on until
the fault is rectified.
Odometer
Fig. 110
Instrument panel: odometer and re-
set button.
The distance covered is displayed in "kilome-
tres" or miles "m". It is possible to change
the measurement units (kilometres
"km"/miles "m") in the radio/Easy Connect*.
Please refer to the Easy Connect* Instructions
Manual for more details.
Instruments and warning lamps
Odometer/trip recorder
The odometer shows the total distance cov-
ered by the vehicle.
The trip recorder shows the distance that has
been travelled since it was last reset. It is
used to measure short trips. The last digit of
the trip recorder indicates distances of 100
metres or tenths of a mile.
The trip recorder can be set to zero by press-
›››
Fig.
110.
ing
0.0/SET
Fault display
If there is a fault in the instrument panel, the
letters DEF will appear in the trip recorder
display. Have the fault repaired immediately,
as far as is possible.
Engine coolant temperature display
For vehicles with no coolant temperature
gauge, a control lamp
appears for high
›››
coolant temperatures
page
207. Please
›››
note
.
The coolant temperature gauge
›››
Fig. 109
only works when the ignition is
switched on. In order to avoid engine dam-
age, please read the following notes for the
different temperature ranges.
Engine cold
If only the diodes in the lower part of the
scale light up, this indicates that the engine
has not yet reached operating temperature.
Avoid high revs and heavy acceleration and
do not make the engine work hard.
Normal temperature
If in normal operations, the diodes light up
until the central zone, it means that the en-
gine has reached operating temperature. At
high outside temperatures and when making
the engine work hard, the diodes may contin-
ue lighting up and reach the upper zone. This
is no cause for concern, provided the control
lamp
does not light up on the instrument
panel digital display.
Heat range
When the diodes light up in the upper area of
the display and the control lamp appears
on the instrument panel display, the coolant
temperature is excessive
CAUTION
2
To ensure a long useful life for the engine,
avoid high revs, driving at high speed and
making the engine work hard for approxi-
mately the first 15 minutes when the engine
is cold. The phase until the engine is warm al-
so depends on the outside temperature. If
necessary, use the engine oil temperature*
›››
page 205
as a guide.
›››
page
207.
»
99

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents