Seat TOLEDO Owner's Manual page 89

Changing dipped beam light bulbs
Changing dipped beam headlight
Fig. 90
bulbs: wheel housing.
Fig. 91 Changing dipped beam headlight
bulbs.
Turn the wheel for access to the wheel
–
housing cover and remove the cover
›››
Fig. 90.
Remove the protective cover from the head-
–
›››
light Fig. 91.
Fuses and bulbs
›››
Remove connector Fig. 91
–
outward.
›››
Unclip the retainer spring Fig. 91
–
pressing clockwise and inwards.
Extract the bulb and fit the replacement so
–
that the lug on the base fits into the recess
on the reflector.
Fit the connector.
–
Fit the protective cover. Make sure that the
–
cover fits correctly on the housing during
operation.
Replace the wheel housing cover.
–
Check whether the new bulb is working.
–
Changing turn signal bulbs
Changing turn signal bulbs.
Fig. 92
Raise the bonnet.
–
by pulling Turn the bulb holder
1 –
clockwise and remove it.
Remove the bulb by pressing on the bulb
2 –
holder and turning it anti-clockwise at the
same time.
Fit the replacement bulb in the bulb holder
–
and turn clockwise as far as it will go.
Check whether the new bulb is working.
–
Changing daytime driving light bulbs
Fig. 93 Changing daytime driving light bulbs.
Raise the bonnet.
–
Turn the bulb holder
–
clockwise and remove it.
Remove the bulb by pressing on the bulb
–
holder and turning it anti-clockwise at the
same time.
›››
Fig. 92 anti-
1
›››
Fig. 93 anti-
1
»
87