Lightly press the defective bulb into the
–
bulb holder, then turn it anti-clockwise and
remove it.
Fit the new bulb, pressing it into the bulb
–
holder and turn it clockwise as far as it will
go.
Use a cloth to remove any fingerprints from
–
the glass part of the bulb.
Check that the new bulb works properly.
–
Re-install the bulb holder
–
Screw in the bulb holder.
–
Position of the bulbs
›››
Fig. 105
Bulb function
Reverse light
A
Side lights
B
Fog lights
C
Note
One of the two sides may not be fitted with a
fog light, depending on the country and type
of driving. In this case, the hole for the light
is covered.
Fitting the bulb-holder
Position the bulb holder on the tail light
–
and align it so that it is securely seated.
92
Screw in the bulb holder using the corre-
–
sponding screw.
Make sure the connector is correctly in
–
place.
Close the inner trim cover.
–
Note
Check the condition of the seal. If damaged, a
replacement can be acquired from an Official
Service.
›››
page
92.
Changing the bulb on the num-
ber plate
P21W
Removing the bulb holder
R5W LL
P21W
Fig. 106
Emergencies
Removing number plate light
Changing the bulb.
Fig. 107
Unscrew the screws to remove the bulb
–
›››
Fig.
106.
Remove the bulb, moving it in the direction
–
›››
of the arrow and outwards
Installation involves all of the above steps
–
in reverse sequence.
Note
Depending on how equipped the vehicle is,
the number plate lights may be LEDs. LEDs
have an estimated life that exceeds than that
of the car. If a light with LEDs fails, go to an
authorised workshop for replacement.
Fig.
107.