Introduction To The Easy Connect System - Seat TOLEDO Owner's Manual

Note
If the battery is disconnected the warning
lamp  lights up when the ignition is switch-
ed on. This warning lamp must switch off af-
ter covering a short distance.
Level of windscreen washer fluid 
If the  warning lamp illuminates, the level
of windscreen washer fluid in the tank is very
low. Fill the windscreen washer fluid
›››
page 209, topping up windscreen washer
fluid.
The informative display indicates:
Refill windscreen washer fluid!
Turn signals  
Depending on the position of the turn signal
lever the left warning lamp on the left  or
right  flashes.
If there is a turn signal fault, the warning
lamp flashes at approximately double the
normal speed.
All the turn signals flash in addition to both
warning lamps when the hazard warning
lights are switched on.
›››
Further information page 124, Turn signal
and main beam lever.

Introduction to the Easy Connect system*

Fog lights 
The control lamp  lights up when the fog
›››
lights are switched on page
Cruise speed 
The  warning lamp illuminates when the
cruise control is switched on (cruise speed)
›››
page 176.
Selector lever lock 
If the  control lamp illuminates, press the
brake pedal. This is necessary when you re-
quire the automatic gearbox selector lever to
move out of the positions P or N
›››
page 161.
Main beam headlights 
The warning lamp  lights up with the main
beam headlights or when the headlights are
›››
page 124.
flashed
Introduction to the Easy
Connect system*
126.
System settings (CAR)*
CAR menu (Setup)
Read the additional information carefully
›››

page 25
To select the settings menus, press the Easy
Connect

button.
The actual number of menus available and
the name of the various options in these me-
nus will depend on the vehicle's electronics
and equipment.
Pressing the menu button will always take
you to the last menu used.
When the function button check box is activa-
ted , the function is active.
Pressing the menu button
you to the last menu used.
Any changes made using the settings menus
are automatically saved on closing those me-
nus.
button and the function
Setup
will always take

»
105