Seat TOLEDO Owner's Manual page 148

Never exceed the allowed axle loads or al-
●
lowed maximum weight. Risk of accident!
CAUTION
Only use SEAT-authorised roof carriers.
●
Where roof carriers from other systems are
●
used or where they are not fitted properly,
any damage caused to the vehicle will not be
covered by the warranty. Therefore, carefully
follow the Instruction Manual for installation
of the roof carrier.
● Remember that the rear lid must not hit the
roof load.
The total height of the vehicle increases ac-
●
cording to the roof load. Compare the height
of the vehicle with the heights of bridges or
other underpasses, for example, the height
of the garage door.
Do not forget to remove the roof carrier be-
●
fore entering an automatic carwash.
● Take into account that the load must not
damage the aerial located on the roof.
For the sake of the environment
If aerodynamic resistance increases, fuel con-
sumption will also increase.
146
Operation
Attachment points
Fig. 165 Basic roof carrier attachment points.
Location of the basic roof carrier attachment
›››
points Fig. 165:
Rear attachment points
A
Front attachment points
B
Install and remove following the instructions
given.
CAUTION
Follow the instructions given in the manual.
Roof load
The maximum permissible roof load (includ-
ing the support system) of 75 kg and the to-
tal authorised weight of the vehicle must not
be exceeded.
It will not be possible to carry the full maxi-
mum load if the roof carrier you are using is
rated for a load which is less than this figure.
In this case, you can only load the roof carrier
to the maximum load permitted in your in-
stallation manual.