Seat TOLEDO Owner's Manual page 124

Closing
Press the respective button gently to close
–
the window. The process will stop when the
button is released.
Safety button 
Press the safety button
activate the controls on the rear doors. Press-
ing the safety button
5
the controls on the rear doors.
If the rear door controls are deactivated, the
warning lamp  on the safety button
light up.
CAUTION
● Keep the windows clean to ensure the sys-
tem operates correctly.
›››
Defrost page 197, Windows and mirrors
●
any frozen windows before use. Otherwise
you run the risk of damaging the electric win-
dow riser mechanism.
● Always make sure all of the windows are
closed on leaving the locked vehicle.
Note
The vehicle heating and ventilation system
●
should be used to ventilate the interior while
driving. Leaving the windows open could al-
low dust and other dirt to enter the vehicle
and cause unpleasant noises at certain
speeds.
122
Do not leave the side windows open at high
●
speeds, as this will overly increase fuel con-
sumption.
Note
The electric window opening mechanism is
›››
Fig. 127 to de-
5
equipped with a thermostat switch. This may
overheat if the window is opened and closed
again will reactivate
repeatedly. This causes the window to lock
temporarily. Once the thermostat switch has
cooled down, the window can be operated
once again.
will
5
Roll-back function on the electric win-
dows
The electric windows are equipped with a
roll-back system that reduces risk of injury
when closing windows.
If an obstacle is present, the closing mecha-
nism will stop and the window will roll back a
few centimetres.
If an obstacle prevents closing for the next
10 seconds, the closing mechanism will once
again stop and the window will roll back an-
other few centimetres.
If in the next 10 seconds you attempt to close
the window after it has rolled back the sec-
ond time, only the closing mechanism will be
stopped even if the obstacle is still present.
The roll-back function is still connected.
Operation
The roll-back function will only be disconnec-
ted if you once again attempt to close the
window in the following 10 seconds. In this
case, the window will close at full force.
If you wait for a further 10 seconds, the roll-
back function will be once again connected.