Seat TOLEDO Owner's Manual page 177

too much traffic or in a car park when there
are good weather and visibility conditions.
Cleaning the camera lens
Keep the camera lens clean and clear of snow
and ice:
● Moisten the lens using a normal alcohol-
based glass cleaning product and clean the
lens with a dry cloth.
● Remove snow using a small brush.
Use de-icing spray to remove any ice.
●
CAUTION
Never use abrasive cleaning products to
●
clean the camera lens.
Do not use hot or warm water to remove ice
●
or snow from the camera lens. Doing so could
damage the camera.
1)
WARNING: the RVC function button will only be ac-
tivated and available when the reverse gear is en-
gaged or the selector lever is set to position R.
Driver assistance systems
Parking and manoeuvring with the
rear assist
Display on the Infotainment system
Fig. 184
screen: orientation lines.
Switching the system on and off
● The rear assist will switch on when the igni-
tion is on or the engine running, on engaging
reverse gear (manual gearbox) or on chang-
ing the selector lever to the R position (auto-
matic gearbox).
● The system switches off 8 seconds after
disengaging reverse gear (manual gearbox)
or removing the selector lever from the R po-
sition (automatic gearbox). The system will
also disconnect immediately after the igni-
tion is switched off.
In combination with the Parking System Plus
›››
page 168, the camera image will cease to
be transmitted immediately when reverse
gear is engaged or when the selector lever is
moved from the R position, and the optical
information provided by the Parking System
Plus will be displayed.
Also in combination with the system, the rear
assist image can also be concealed:
● By pressing one of the Infotainment system
buttons on the display.
● OR: By pressing the miniature vehicle that
appears on the left of the screen (which
switches to the full-screen mode of the Park-
ing System Plus's optical system).
If you wish to display the rear assist image
again:
● Disengage reverse, or change the selector
lever's position, engage reverse again or
move the selector lever to position R.
OR: Press the RVC function button
●
Meaning of the orientation lines
›››
Fig. 184
1)
»
175