Program To Initialize Fx 3U -4Da (Factory Default) - Mitsubishi Electric FX3G User Manual

FX /FX /FX /FX /FX
3S 3G 3GC 3U 3UC
FX -4DA (4-channel Analog Output)
3U
M1
FNC 78
FROM
M30
FNC228
K0
LD<>
8.4 Program to Initialize FX
To initialize FX
3U
This will return the output mode (BFM#0), the offset data (BFM#10 to #13) and the gain data (BFM#14 to #17)
will be to the factory default status state.
1. Conditions
The sequence program described in this section is under the following conditions.
1) System configuration
FX -4DA (unit No.0) should be connected to the FX
3U
2) Device assignment
Device
X000
2. Example of sequence program
• For FX /FX
3U 3UC
4DA initialization command
X000
• For FX /FX
3G 3GC
4DA initialization command
X000
FNC 79
TO P
3. Cautions regarding initializing
• During initialization, output is stopped, and H0000 is automatically written in the output status (BFM#6).
At the completion of initialization, the output status (BFM#6) will automatically change to H1111, and the
output will be restarted.
• It takes approximately 5 seconds to complete initialization. Do not set (write) data in the buffer memory
during the period.
• Priority is given to the setting of the change prohibition mode (BFM#19).
• Once initialization is completed, the value in BFM#20 will automatically change to "K0".
PLC User's Manual - Analog Control Edition
K0 K89 D101
FNC 12
D101
MOV
Y000
D102 Y001
-4DA (Factory Default)
3U
-4DA, execute the following program.
Description
4DA initialization command
Series PLCs
FNC 12
K1
MOV
P
/FX /FX Series PLCs
3U 3UC
K0 K20 K1
8 Examples of Practical Programs
8.4 Program to Initialize FX3U-4DA (Factory Default)
Readout table output completion flag and table
K2
output error
K4M30
Completion of table output from channel 1
Output to Y000
Output to Y001 when table output error occurs
Series PLC.
3U
The 4DA will be initialized.
U0\G20
(BFM#0 to #3098 will be cleared.)
The 4DA will be initialized.
K1
(BFM#0 to #3098 will be cleared.)
A
B
C
D
E
F
G
H
I
J
E-63