Avaya 3740 User Manual page 119

No access
No System. The
handset beeps once a
minute (during max 30
minutes) with a low
tone followed by a
high tone (if enabled,
the vibrator also
follows the beeps).
No flash driver was
found
Note: This display
message is only
shown in English.
SERVICE NEEDED
Hardware error
Note: This display
message is only
shown in English.
SERVICE NEEDED
Invalid IPDI
Note: This display
message is only
shown in English.
SERVICE NEEDED
Parameters corrupt.
Note: This display
message is only
shown in English.
Enter PIN code
Battery low, charge
now
Phonebook is not
available at the
moment.
Avaya 374x DECT Telephones - User Guide
The network is in range, but no
access rights.
The handset is out of coverage
or handset is defective.
Failed to read from flash
There is a communication
problem between components in
the handset.
Easy replacement procedure not
followed correctly or failure
during easy replacement
procedure.
The handset is defective.
The handset's lock is activated. Enter the required PIN code.
The battery level is low.
The phonebook does not
respond, not available at the
moment.
Troubleshooting
Switch handset off and then
switch it on again or contact
system administrator.
Stop the beep with the Sound
off key and go into range.
Note: When re-entering the
coverage area it can take a
couple of minutes before the
handset automatically has
registered into the system.
or
contact system administrator.
Send the handset for service.
Restart the handset. If the
problem persists, send the
handset for service.
Send the handset for service.
Select reset option on the
middle soft key if available or
if no reset option is available
or fault does not resolve the
handset needs repair. Note:
Display message only shown
in English.
If PIN code lost enter new via
PDM/Device Manager or do a
factory reset via PDM/Device
Manager.
Charge or replace the battery.
Try again later or if fault
persists do a factory reset via
admin menu or PDM/Device
Manager.
02/2016
119