Message Priority And Call Priority; Message Indication Repetition; Color Messaging - Avaya 3740 User Manual

Message Priority and Call Priority

The default setting is that the call information dialog is always visible in front of a message on
incoming calls. A message with a certain priority can be configured to ensure that it is always
displayed without being interrupted by a call. By setting a call priority, the handset compares the
call priority with the message priority to determine which information to be displayed, that is, the
call information dialog or the message. If the message priority and the call priority are equal, the
message is displayed.
See the handset's Configuration Manual for more information how to set the parameters.

Message Indication Repetition

By default, when a new message is received or displayed, the LED starts flashing green once
and the message alert signal sounds. It is possible to configure the handset to repeat the alert
signal for an unread message every 7th second as long it is displayed. See the handset's
Configuration Manual for message settings.
Priority 1 messages with certain system-defined properties are handled as extra important and
therefore will the alert signal be repeated every 10th second in 5 minutes, or until any key is
pressed. Note that this is a system/application dependent feature and cannot be configured in
the handset.

Color Messaging

It is possible to send colored messages to handsets. The sender of a message (that is, an
application) determines the color of the message. Colored messaging can be useful for
categorizing messages. In
message, and a read message) in the message inbox (left in the figure). The messages are
indicated by a gradient colour bar behind the envelopes. In addition, a gradient color bar is
shown below the envelop when reading a colored message (right in the figure).
Avaya 374x DECT Telephones - User Guide
figure 9 on page 112, there are two colored messages (a new
Enhanced Messaging
111
02/2016