Honda InterceptorVF700F Shop Manual page 149

EIOIUTDA
V45 INTERCEPTOR
C Y L I N D E R H E A D / V A L V E
Install the intake and exhaust camshafts and
sprockets through the rear cylinder cam chain as
shown.
Turn the camshafts so the camshaft marks face up.
N O T E
lf the front cylinder camshafts were not
removed, check that the front camshaft marks
face up. lf not, turn the crankshaft counter-
clockwise 360 degrees (one turn).
lf a valve clearance adjuster keeps the camshaft
from seating fully in the cylinder head, back the
adjuster out all the way.
CAUTION
If you force a valve open while installing
the camshaft holders, you may damage the
holers or the camshaft bearing surfaces.
Place the camshaft holders in the same locations
noted during removal. The groove in the bottom
of the holder must align with the camshaft locating
ridge.
Install the camshaft holder bolts, but do not tighten
them yet.
N O T E
The camshaft holder bolts in each corner of
the cylinder head are longer than the others.
C A M S H A F T M A R K S
2
' \
ii..1::,;;,
rilt{du,,
1 0 - 2 0
Date of lssue: October, 1983
@ HONDA MOTOR CO., LTD.
, ,'rit::l;,'l lt:'