Honda InterceptorVF700F Shop Manual page 208

II(TVDA.
V45 INTERGEPTOR
F R O N T W H E E L / S U S P E N S I O N
I N S T A L L A T I O N
Position the wheel between the fork legs.
Lower the engine so the fork legs rest on the top of
t h e a x l e .
Position the tang on the speedometer gear box
against the lug on the left fork leg.
lnstall the axle holders with the arrow pointing
forward.
Install the right front caliper and tighten the mount
bolts.
TOROUE: 30=40 N.m (3.0-4.0 kg-m, 22-29 ft'lb)
Tighten the right axle holder nuts to the specified
torque, starting with the forward nut.
T O R O U E ; 1 8 - 2 5 N . m ( 1 . 8 - 2 . 5 k g ' m , 1 3 - 1 8 f t ' l b )
Install the left front caliper.
Tighten the anti-dive pivot bolt.
TOROUE: 20-25 N.m (2.0-2.5 ks'm,14-18 ft'lb)
T i g h t e n t h e c a l i p e r m o u n t b o l t .
TOROUE: 30-40 N.m (3.0-4.0 ks-m,22-29 ft'lb)
Connect the speedometer cable and secure it with
the set screw.
Measure the clearance between each surface of the
left brake disc and the left caliper holder with a 0.7
mm (0.028 in) feeler gauge. lf the gauge inserts
easily, tighten the forward left axle holder nut to
the specified torque, then tighten the rear nut.
lf the feeler gauge canndt be inserted easily, pull the
left fork out or push it in until the gauge can be
inserted.
After installing the wheel, apply the brake several
times, then recheck both discs for caliper holder to
disc clearance.
0.7 mm (0.028 in)
C A L I P E R
H O L D E R
B R A K E D I S C
T A N G
A R R O W M A R K
C A L I P E R M O U N T B O L T C A L I P E R M O U N T B O L T
A N T I . D I V E P I V O T B O L T
D a t e o f l s s u e : O c t o b e r , 1 9 8 3
O H O N D A M O T O R C O . , L T D .
1 4 - 1 7