Danfoss VLT AutomationDrive FC 300 Operating Instructions Manual page 28

How to Install
Terminal locations - Inverter
FASTENER TORQUE: MIO 19 Nm (14 FT -LB) FASTENER TORQUE: MIO 19 Nm (14 FT -LB) FASTENER TORQUE: MIO 19 Nm (14 FT -LB)
U/T1 96 V/T2 97 W/T3 98 U/T1 96 V/T2 97 W/T3 98 U/T1 96 V/T2 97
Illustration 4.14 Terminal locations - Inverter Cabinet
(front, left and right side view). The gland plate is 42 mm below .0 level.
1) Earth ground bar
2) Motor terminals
3) Brake terminals
Table 4.9
VLT Automation Low Harmonic Drive Operating Instructions
W/T3 98
1
2
3
®
MG34O202 - VLT is a registered Danfoss trademark
308.3 [12.14]
253.1 [9.96]
180.3 [7.10]
0.0 [0.00]
2
3
4 4
Section shown
↓
27