How To Read These Operating Instructions; Copyright, Limitation Of Liability And Revision Rights; Approvals - Danfoss VLT AutomationDrive FC 300 Operating Instructions Manual

How to Read these Operating...
1 1

1 How to Read these Operating Instructions

1.1.1 Copyright, Limitation of Liability and
Revision Rights
This publication contains information proprietary to
Danfoss. By accepting and using this manual the user
agrees that the information contained herein will be used
solely for operating equipment from Danfoss or equipment
from other vendors provided that such equipment is
intended for communication with Danfoss equipment over
a serial communication link. This publication is protected
under the Copyright laws of Denmark and most other
countries.
Danfoss does not warrant that a software program
produced according to the guidelines provided in this
manual will function properly in every physical, hardware
or software environment.
Although Danfoss has tested and reviewed the documen-
tation within this manual, Danfoss makes no warranty or
representation, neither expressed nor implied, with respect
to this documentation, including its quality, performance,
or fitness for a particular purpose.
In no event shall Danfoss be liable for direct, indirect,
special, incidental, or consequential damages arising out of
the use, or the inability to use information contained in
this manual, even if advised of the possibility of such
damages. In particular, Danfoss is not responsible for any
costs, including but not limited to those incurred as a
result of lost profits or revenue, loss or damage of
equipment, loss of computer programs, loss of data, the
costs to substitute these, or any claims by third parties.
Danfoss reserves the right to revise this publication at any
time and to make changes to its contents without prior
notice or any obligation to notify former or present users
of such revisions or changes.
1.1.2 Available Literature for VLT
AutomationDrive
- The VLT AutomationDrive Operating Instructions -
High Power, MG33UXYY provide the necessary
information for getting the frequency converter
up and running.
- The VLT AutomationDrive Design Guide MG33BXYY
entails all technical information about the
frequency converter and customer design and
applications.
- The VLT AutomationDrive Programming Guide
MG33MXYY provides information on how to
4
VLT Automation Low Harmonic Drive Operating Instructions
-
-
X = Revision number
YY = Language code
Danfoss technical literature is also available online at
www.danfoss.com/drives.
These Operating Instructions can be used for all VLT Automation
Low Harmonic Drive frequency converters with software version
6.5x.
The software version number can be seen from 15-43 Software
Version.
Table 1.1
NOTE
The Low Harmonic Drive has two LCPs, one for the
frequency converter (to the right) and one for the active
filter (to the left). Each LCP controls only the unit it is
connected to and there is only a start/stop signal between
the two units.

1.1.3 Approvals

Table 1.2
®
MG34O202 - VLT is a registered Danfoss trademark
programme and includes complete parameter
descriptions.
The VLT AutomationDrive Profibus Operating
Instructions MG33CXYY provide the information
required for controlling, monitoring and
programming the frequency converter via a
Profibus fieldbus.
The VLT AutomationDrive DeviceNet Operating
Instructions MG33DXYY provide the information
required for controlling, monitoring and
programming the frequency converter via a
DeviceNet fieldbus.
VLT AutomationDrive
Operating Instructions
Software version: 6.5x