Honda CRF110F Service Manual page 163

Install the gearshift spindle [11 so that the shift return
spring pin {2] is located between both ends of the return
spring {31 as shown. . •
Insert the gearshift spindle completely while holding
down the gearshift arm [41 as shown.
CLUTCH/GEARSHIFT LINKAGE
Install the shift drum side plate [1] and gearshift cam
~~~~~~~~~=~~~~~~~::::;
plate [2] while aligning the holes on the plates with the
side plate pins.
Apply locking agent (Three Bond 1322 or equivalent) to
the gearshift cam plate bolt [3J as specified, then install
and tighten it to the specified torque.
TORQUE: 17 N·m (1.7 kgf-m, 131bHt)
Apply locking agent (Three Bond 1322 or equivalent) to
~=~~~~~;"'~~~~~~:;:
the shift drum stopper armlbolt [1J as specified.
Set the return spring end {2] along the crankcase wall
as shown.
Install the stopper armlbolt, then tighten it to the
1,-; ... -;;,.... ...
1:'
specified torque.
TORQUE: 10 N·m (1 .0 kgf·m, 7Ibf·h)
Install the gearshift pedal (1] to its original position as
~~iIi~;;~~=~~~:;~;:~
marl<ed during removal.
Install and lighten the bolt (2] to the specified torque.
TORQUE : 12 N·m (1 .2 kgf·m, 9 IbHt)
Install the clutch (page 10-23).
10-29