Engine Installation - Honda CRF110F Service Manual

Remove the drive sprocket fixing plale bolts [1].
Tum and remove the fixing plale [2j.
Remove the drive sprocket (3) from the counlershaft
and drive chain.
ENGINE REMOVAUINSTALLA TION
Support the motorcycle securely and raise the rear . . -..."
wheel off the ground with a hoist or equivalent.
Support the engine using a jack or other adjustable
support.
Remove the front engine hanger nul [1J.
Remove the rear upper engine hanger nut [2J and rear
lower engine hanger nut [3].
Remove the engine hanger bolls and engine from Ihe
frame.
Wrap the intake manifold
port
with a shop towel or
cover it
with
a piece of tape to prevent any foreign
malerial from dropping into the engine.
ENGINE INSTALLATION
During engine
installation, hold the
engine securely
and be careful not
to
damage the
frame and engine.
NOTE:
Note the direction of the hanger bolts.
Use a floor jack or other adjustable support, carefully
place the engine Into the frame and maneuver it into
place.
Route the wires and hoses properly (page 1-14).
Place the engine into the frame and support the engine
using a jack or other adjustable support.
Install the engine hanger bolts and nuts.
Tighten the rear upper engine hanger nut [1) to the
specified torque.
TORQUE: 54 N'm (5.5 kgf'm , 40 IbHt)
Tighten the rear lower engine hanger nut
[2]
to the
specified torque.
TORQUE: 54 N'm (5.5 kgf-m, 40 IbHt)
Tighten the front engine hanger nut [3) to the specified
torque.
TORQUE : 54 N'm (5.5 kgf'm , 40 IbHt)
13-5