Intake Pipe Removal/Installation; Carburetor Removal - Honda CRF110F Service Manual

FUEL SYSTEM
INTAKE PIPE
REMOVAL/INSTALLATION
Remoye the following :
- Carburetor mounting bolls [1]
- Intake
pipe
mounting bolts 12]
- Wire guide (3)
- Intake pipe [4)
Replace the O-ring (1] and gasket [2 J new ones.
Installation is in the reverse order of removal.
TORQUE:
Intake pipe mounting bolt:
12 N 'm (1 .2 kgf'm, 9 IbUt)
CARBURETOR
REMOVAL
6-6
Remove the right fuel tank shroud (page 2-3).
Turn the fuel valve OFF.
Place an approved gasoline container under the drain
hose
[1]
and toosen the drain screw to drain the fuel.
Tighten the drain screw to the specified torque.
TORQUE: 1.5 N'm (0.15 kgf-m , 1.1 IbHt)
Release the drain hose from the hose guide [21 .
Disconnect the fuel hose [31 from the carburetor.
Loosen the carburetor top [1] and put! the throttle valve
out.
g [21
~
S
[1]
~
O?~
•