Honda CRF110F Service Manual page 85

The Air scre w is
factory pre-sel.
When not
necessary, do not
tum or disassemble
the air scrow.
Remove the float pin [1
j,
float [2] and float valve [3].
Inspect the float for deformation or damage.
Inspect the float valve seal [11 for scores, scratches,
clogging and damage.
Check the tip of the floa t valve [2 ] where
it
con ta cts the
valve seat for stepped wear or contamination.
Replace the valve if the lip is worn or contaminated.
Remove the following:
- Throllie slop screw [1)
Spring [21
Main jet (3)
Needle jet holder [4 J
Needle jet [51
Slow jet [6)
Remove the tamper-proof plug [1).
Turn the air screw {2J in and record the number of turns
it takes before il seals lightly.
• Damage to the air screw seal will occur
jf
the air
screw is lightened against the seat.
TOOLS :
Pilot screw wrench (0 type) 07KMA·MS60102 or
07KMA·MN9A100
(U.S.A. only)
Remove the follow ing:
- Airscrew
- Spring [3]
- Washer [4]
- O·ring [5]
FUEL SYSTEM
[2[
[5[
/ [4[
A
[61 [31
[11
[51 [41 [31 1 21
6-9