Printing-Modes - Stratasys J750 User Manual

Stratasys J750 User Guide

Printing-Modes

When printing the tray file, the Build dialog box opens in which you need to
select the appropriate printing mode. (See "Printing the Tray" on the previous
page.)
High-Speed Mode
Models are produced in 27-micron layers, using up to three Model
materials. This mode is suitable for producing larger models.
Much less time is required to print most trays, compared to the High Quality
setting.
High-Mix Mode
Models are printed in 27-micron layers, using up to six Model materials. This
mode is suitable for producing larger models.
Printing models in this mode is faster than in High Quality mode, but not as
fast as in High-Speed mode.
High-Quality Mode
Models are printed in 14-micron layers, using up to six Model materials. This
results in smooth surfaces, suitable for producing fine-detailed and delicate
items.
Almost twice as much time is required to print most trays, compared to the
High Speed setting.
DOC-08010 Rev. E
5 Using PolyJet Studio
5-38